Tengda Wireless Router How to set up dynamic IP Internet?

2, (a light cat) to the light cat out of a network cable to connect the router's WAN (blue logo), and then find a short network cable, a computer, a router 1/2/3 arbitrary interface (yellow), wiring mode as shown below:

Note: When powered on, the router is working normally with the SYS LEDs flashing, WAN LEDs illuminated steady or blinking, and the 1/2/3 port LEDs attached to the computer are illuminated steady or blinking. such as wiring after the corresponding 1/2/3 port led does not light or the computer network card icon shows a red fork

, it shows

There is a problem with the line connection, try to check the network cable Connection or change the root network cable to try.

Set the local connection IP address on your computer to "Get IP address automatically"

1, click on the desktop in the bottom right corner of the network icon, open the network and Sharing Center

Win8 System gets IP automatically

2, click "Change Adapter Settings"

3, right click on "Local Connection" to select "Properties"

4. Double-click Internet Protocol version 4 (TCP/IP)

5, select "Automatically obtain IP address", "Automatically obtain DNS server address", click "OK"-"OK".

1, open the browser

, enter in the browser address bar: 192.168.0.1 Press ENTER to login settings interface.

192.168.0.1 not open? Please click this link

2, select "Dynamic IP" in the Setup page, click "OK".

After the setup is complete, if the networking status shows "Connected", you can browse the Web and surf the Internet.