Tengda Wireless Router How to set up dynamic IP internet (Optical access)

2, (a light cat) to the light cat out of a network cable to connect the router's WAN (blue logo), and then find a short network cable, a computer, a router 1/2/3 arbitrary interface (yellow), wiring mode as shown below:

Note: when powered on, the router is working normally with the SYS LEDs flashing, WAN LEDs illuminated steady or blinking, and the 1/2/3 port LEDs attached to the computer are illuminated steady or blinking. such as the wiring after the corresponding 1/2/3 port LED is not bright or the computer network card icon shows a red fork, it indicates

There is a problem with the line connection, try to check the network cable Connection or change the root network cable to try.

Set the local connection IP address on your computer to " get IP address automatically "

1, click on the desktop in the bottom right corner of the network icon, open the Network and Sharing Center

Win8 system gets IP automatically

2 , Click " Change adapter Settings "

3 , Right click on " local connection " to select " Properties "

4 , Double-clickInternet protocol version 4(TCP/IP)

5 , select " automatically obtain IP address ", " automatically obtain DNS server Address ", click " OK-" OK . " "

1 , Open the browser, in the browser address bar input:192.168.0.1 Press ENTER login settings interface.

192.168.0.1 can't open it? Please click this link

2 , Select " dynamic IP" on the Setup page and click " OK ".

After the setup is complete, if the networking status shows "Connected", you can browse the Web and surf the Internet.