The entire process of PPPOE configuration for lingke Router

The whole process of configuring the pppoe method of the lingke router today is the configuration process of the routers and computers when the PPPOE method is used, you can learn more about vro setting. 1. Connect the telephone line to the MODEM, connect the WAN port of the router to the LAN port of the MODEM, and connect the computer to any LAN port of the router, connect the network cable to the WAN port of the router.
2. Specify an IP address for the computer. Of course, the IP address can also be obtained automatically. If there are not many computers, you are advised to manually specify the IP address. 3. Right-click "Network Neighbor" on the desktop and choose "properties" from the shortcut menu. Right-click "properties" on the local connection to open the properties of the TCP/IP protocol. Select "automatically get IP Address" and "automatically get DNS server address". Click "OK, click Start-run on the computer, Enter CMD to confirm, and enter ipconfig/all in the Command Prompt window. If an IP address is displayed, the NIC has obtained the IP address from the vro. Www.2cto.com
4. If the IP address cannot be obtained or the obtained IP address is 169.254.X.X, manually specify the IP address, right-click "Network Neighbor" on the desktop, select "properties", and right-click "properties" on the local connection, select Internet Protocol (TCP/IP), click Properties, and set the local IP address here. The default LAN port IP address of the router is 192.168.1.1, so the gateway needs to be set to 192.168.1.1. 5. About DNS, you can ask the broadband provider for the DNS server address and enter it in the dialog box. You can also leave it empty. After obtaining the IP address and DNS server address from the WAN port of the router, then enter the obtained DNS in the computer.
6. Open IE browser and enter 192.168.1.1 in the address bar to display the vro management interface dialog box. Enter the account and password and click OK to go to The vro management interface, click network parameters-WAN port settings to go To the WAN port settings page, select PPPOE In the WAN port connection type, enter your internet account and password, and save the settings, select the corresponding connection method and click Connect. 7. The IP address and DNS address obtained by the vro are displayed in the running status. If the IP address and DNS address are not obtained, check the route and check whether there is any connection. After entering the internet password, the length of the password in the password box is different from the actual number of digits. This is because of the built-in password protection mechanism of the vro, make sure that you have entered the correct password.