The power of bridging is not available for VMware virtual machine NAT Solutions!

Because the recognition and sharing mechanism of the campus network will mistakenly identify the virtual machine's NAT to be shared. Here I need to explain the difference between NAT and bridging:

NAT in the network connection, the host as a router to use, the advantage is that the private IP address can be converted to a public IP address (host address), the request sent out, can save the problem of insufficient IP address;

Network bridging mode, you can think of the LAN access to a new computer, using two IP addresses (in the same network segment), that is to say, if you are using the campus network, can only make a choice between the virtual system and the host, other users do not consider.

The vmware12,win7 system is used here.

Bridging method:

① Select the virtual machine settings, select the bridging mode, determine

② start the virtual machine, run the system (so that it is easy to debug later, you can see the network connection directly in the virtual machine)

③ Editing a virtual network

Click Edit Virtual Network Editor

Then click Change Settings

After entering, become three options, this time do not panic, because the problem is not big! You only need to go back to the host (host system),

Open this computer, locate the network, right-click Properties, and click Change adapter settings.

At this point you will see these connections, choose your network of virtual network card corresponding to the next label

(If it is a network cable, select Ethernet, if it is dial-up, there will be a dial-up connection; WiFi, choose WLAN);

The other three are network interfaces for Host-only mode, host for virtual network cards to communicate with host-only virtual networks, host for virtual network cards to communicate with NAT virtual networks

Select the bridge mode that line, here, my networking Way is Ethernet,

So select "Killer e2400 Gigabit Ethernet Controller" network card, OK.

④ Check the network, complete the above steps can now be on the virtual machine can be online.

⑤ If this doesn't make the internet available, try changing the adapter by clicking Properties, Network, virtual machine system

Local connection, Property->internet Protocol 4-> property, set IP address to get automatically

Do not know whether to solve your problem? Welcome comment private Me [email protected]

The power of bridging is not available for VMware virtual machine NAT Solutions!