The production of the stamp effect in fireworks

1. New file width=300,height=300, here we set the background color to Golden

2. In the editing area, drag a rectangle with a rectangular tool to draw a rectangle with a black fill. Open the Storke panel and set it as shown (Figure 1). Then click on the black arrow on the top right of the Storke panel to select Edit Storke in the pop-up menu.



3, in the pop-up box set as follows, the spacing (step) set to 170% (Figure 2)



4, open a picture, drag the picture to the editing area, adjust their upper and lower positions, the teeth of the rectangle on the picture above, as shown (Figure 3). Select them at the same time, modify---mask---Group as mask. The effect came out.

5. Add words to the stamp and the final result is as shown (Figure 4)



When I was complacent, someone said: "No, I have seen the teeth of the stamp is white, the middle of the picture is surrounded by a white box." Run to buy a stamp at once, sure enough, as the man said. Never mind, let's do it again


White serrated stamp

1, new file width=300,height=300, background color is golden,

2, using the rectangular tool in the editing area to drag and draw a rectangle, the fill color is white. Set to none in the Storke panel without strokes.

3, select the white rectangle, edit---clone, change the filled color of the cloned rectangle to black, and then modify---transform---numeric transform in the pop-up box to reduce the original length and width by 15 pixels, as shown in Figure 5.

Now the effect diagram is like this (Figure 6)



4, select the white rectangle, open the Storke panel, set as shown (Figure 1), point Storke Panel on the upper right corner of the black small arrow, in the pop-up menu select Edit Storke, in the pop-up box spacing set to 170%, other for the default.

5, open the picture, use tools to drag pictures to the edit area, and then adjust their upper and lower layers, place the black rectangle on top, the picture on the second floor, and the white gear rectangle at the bottom. Also select the black rectangle and picture, modify---mask---group as mask. Be satisfied! Don't forget to add words to it, the final effect is as shown (Figure 7)



Teach you a little trick, if you are not satisfied with the position of the picture in the stamp, you can in the Layers panel, the mask to open the link (Figure 8) and then move the picture to a satisfactory location.



Okay, let's shiver here today.