The solution to the problem of the input of the TGA sequence by phantom particles into PS is unclear

Some sequences have been produced in the phantom particles, of course, except for the TGA sequence there are some other formats of the sequence picture, and when we put the produced here I produced the TGA sequence into PS, I found that either a picture or a sequence pixel changed. What do we do with this situation?

1. First, we click on the script in the file pull-down menu----Load the file onto the stack.

2, then in the pop-up panel selection browsing, select the production of TGA sequence pictures. Click on the first picture and use the shortcut key ctr+a to select all.

3, after the import, we can see that its picture pixel and did not import before the difference is very large. Such a picture is to be imported into the here is also can not be used.

4, then we try the TIF format of the sequence of pictures. We select the script under the File menu---Load the file into the stack, then select Browse in the pop-up panel, then open our TIF sequence, click on the keyboard ctr+a all SELECT, click OK.

5, in the open sequence of pictures above we can see that its pixel is also very poor, do not see the effect of particles.

6, then look at the PNG format of the sequence of material, the same way to click on the browse Open. It is not possible to see its pixels.

7, finally, we will try the PSD format of the sequence of picture footage, to see how its pixel. After the import we can see that its pixels are unchanged.

8, sometimes may be due to various factors, resulting in some pictures of the material changes. At this time we are trying to use a different format to save to achieve the best image effect.

Category:

• PS Getting Started Tutorial