The status quo of it fetish 38-get my laptop to surf the web-bridging technology without wiring

The former said Wei Tsai changed a notebook, i7 processor +8g memory +1t hard disk +128g SSD, very happy. Bring your own genuine WIN8 system, try to run for nearly a week found no problem (referring to the hardware), decisive change the system to Ubuntu14.04, so one is to develop the convenience of Android, and the second is really like the command line to work bright. But the problem followed, I found the WiFi module driver has a problem, wifi when the good bad, really affected my work.

First of all, my computer desk is very far from the network, so the cable is not considered. What about adding a WiFi module? One day my brain hole big open, will give Raspberry Pi bought the WiFi module inserted in the notebook, really good! I thought this solved the problem, but after running for a while, the external WiFi module caused the network to be broken. I think the laptop comes with the WiFi module is also because of this problem and not use it? What's the good of that?

Consider acquiring such a device, a wireless repeater that can receive WiFi signals and output with a network cable. This will solve my embarrassment. Find some products, inadvertently found the ordinary no line from can also do, is to use the so-called bridging technology will be two no line by connecting up, so you can send a large WiFi signal can also be the output of its network cable, and I need the "wireless repeater" is the same, so that the room is full of wifi,good!

Originally home has two wireless routers, is also the same factory, the conditions are satisfied, then say dry. In the Universe good Netizen's Raiders help, I took care of it once. The steps are described below (as is not a picture):
Connect to No Line by (IP and username password on the back of router), wired and wireless are available.
settings for the main route
Simply change the channel number to fixed. The rest of the settings, such as passwords, follow the original.
Specific setup steps: Wireless Settings-Basic settings: Channel number, such as set to 8.

Sub-route settings
1, modify the LAN port IP
Network parameter--lan port setting: Change IP to be different from main route
2. Turn on WDS
Wireless Settings-Basic settings: Turn on WDS (this is the focus of this article, I hope your router has this feature), click "Scan", select the main route in the results list and click "Connect", then fill in the password, save.
3, the channel number and the main route set consistent, the above 8.
4. Shut down the DHCP server (just not enabled)
5, see whether the wireless status is a success

If all goes well, the wireless bridge is set up successfully. After manually restarting the route, I immediately plugged in the network cable test, the Web page opened smoothly. Oh, yes! Until I write this article, everything goes well!

Copyright NOTICE: This article for Bo Master original article, without Bo Master permission not reproduced.

The status quo of it fetish 38-get my laptop to surf the web-bridging technology without wiring