Three online selection methods for D-LINK Routers

As we all know, the home gateway products produced by D-link and the new DIR series are available in three online methods in PPPoE settings, that is, the options of automatic online, manual online, and traffic-based connection provide users with the options they need.
1. manually select this method online. before accessing the internet, you need to enter the D-link router configuration interface. In the system status, manually click the link to connect the system to the network; when you do not need to access the Internet, you also need to manually enter the D-link router configuration interface and click disconnected.
2. automatically connect to the network whenever you connect to the D-link router, it is suitable for monthly subscription users. For monthly subscription users, if the D-link router is not disabled every time the computer is shut down, the network is still smooth, the D-link router will automatically dial continuously, which means that it will not stop requesting the ISP to provide broadband network services, and will produce high network fees without your knowledge, note that the D-link router is powered off when no Internet access is available.
3. Select this mode when there is traffic and set the maximum idle time. If no one is able to perform the operation, the system will automatically disconnect the connection after the maximum idle time is reached at www.2cto.com, however, some programs in the computer have functions such as automatic update and automatic network detection. Therefore, data packets are automatically sent when they are connected to the LAN port (or wirelessly connected, in this way, packets are automatically sent to the network or even some computers due to virus programs. As a result, even if no manual operation is performed on the Internet, the system still detects the traffic and goes online. To sum up, for users who access the Internet for a limited time, and choose the connection mode when there is traffic, it is best to disable the D-link router when no Internet access is available, to avoid the case of boot, unknown programs send data packets.
Select the automatic connection mode and disable the vro when no Internet access is available. If you select the manual connection mode, you must click disconnect on the D-link router configuration interface when no Internet access is available, refresh and check whether the IP address of the WAN end is 0.0.0.0. This article is from