Time Setting of the mercury Router

The average person does not care too much about the time of the router, but if it is a user who uses time-based Internet access, the time setting of the router is essential to prevent exceeding the specified time for Internet access, the following describes how to set the time of the router.
First of all, log on to the mercury router, click the left-side navigation bar, choose System Tools> time settings, as shown in, set the system time of the router, you can set the time manually or obtain the standard GMT time from the Internet.

I. Give priority to NTP servers
This item is used to set the IP address of the NTP server (up to two IP addresses can be entered). The NTP server is a network time server for computer time synchronization on the Internet. Www.2cto.com the mercury router has some frequently-used NTP server addresses. Once connected to the Internet, the router can automatically obtain the system time. However, if this item is set here, when the vro obtains the GMT time, it first obtains it from the configured time server.
Ii. Time Setting Method
(1) to manually set the time, first select the time zone, then fill in the corresponding value in the date and time columns, and then click the Save button to complete the system time setting. (2) to get the GMT time, first connect to the Internet, select the time zone, and then click the get GMT button to get the standard GMT time from the Internet.
Note: 1. After the vro is powered off, the time information will be lost. The vrogmt will automatically obtain the GMT time only after the vrogmt is connected to the Internet again. 2. You must set the system time before the time limit in other vro functions takes effect. 3. When you select to manually set the time, to view the current system time, refresh the time settings page. This article is from