Tips for using a mobile hard disk as a PE boot disk

Reference 1 System Requirements: To make a mobile hard drive boot disk, first of all to confirm that the motherboard supports USB-HDD, memory greater than 256 MB. The latest old 9 winpe old Mao Tao (build 070911) has a simple structure and is easier to install. Step 1: format the mobile hard disk and set the active partition. 1. Plug in the mobile hard disk, divide the mobile hard disk into partitions, set the first partition as the primary partition, and activate it as the active partition. 2. Click the first drive letter H of the mobile hard disk and right-click "Run formatting". The machine experiment FAT32 and NTFS formats are supported. Step 2: copy the PE file to the active partition on the hard disk. 3. decompress the downloaded winpe file. 4. Click Open winpe To uncompress the file. First, run the setup.exe file under the folder to load the Startup file to the disk. (Tip: some security software may prompt that an unknown process exists in this step. Please temporarily close 360, rising, Kingsoft, and so on ...) 5. Set winnt. copy xpe to the H disk (that is, the first active partition of the mobile hard disk), open the wxpe folder, and set ntdetect. COM and setupldr. copy bin to the H disk and set setupldr. the binfile is renamed ntldr. Remove the extension. Copy the minipe folder to the H disk. 6, restart the computer, boot press delete, enter the bios, set the first start to USB-HDD, save and quit. Reference 2

Preparation: one mobile hard drive, one downloaded win7 ISO, one available system, decompression software or virtual Optical Drive Software

 

Operation:

1. Clear a partition of the mobile hard disk, format it as the primary partition, and set it as activity;

2. Decompress or use a virtual optical drive to decompress or extract all files in the ISO file to the hard drive partition (assumed as disk X );

3. "Start-run-input cmd" in the current system [run as Administrator]

4. Run the command line [Note: X loads the Partition Number of the known pressure file for you]

The commands are as follows [three-line commands]:

X:

CD boot

Bootsect/nt60 X:/force/MBR

 

5. restart the computer.

6. When the machine is started, pay attention to how to choose the startup sequence (usually Press ESC, F2, or F12, and pay attention to the system prompts for details ). Press the corresponding buttons to go to the select device startup interface.

Select Start with USB.

7, OK. Press enter to start installation.

 

 

Recommendation Area

Old peachWinpe Official Website