The Hyfi router is used with the Extender to extend the network to all corners by wire, without having to lay out the net cable to achieve full Wi-Fi coverage, and to achieve the roaming effect. As follows:
This article is to guide the use of computers to set up tl-h39r/tl-h39e packages to connect broadband Internet access.
Note: Hyfi routers are typically used with extenders, and the number of extenders is added according to actual needs.
Broadband lines, such as fibre, telephone, and cable, may be connected in a different way, connect the broadband cable (the network cable connecting the computer to the Internet) to the router Wan, as follows:
2
, connect the wireless signal
Mobile phone search and connect the TP-LINK_HYFI_XX signal name, the signal name at the bottom of the router logo, as follows:
This signal is temporarily used to set up the Hyfi router, and the signal disappears when the setting is complete. The following figure:
Note : If the factory default signal is not searched, it may have been set, it is recommended to
reset the
hyfi
Road
by the device
.
3
, enter the Hyfi Router management interface
After successfully connecting the wireless signal of the router, open the mobile browser, enter
tplogin.cn(or 192.168.1.1) in the address bar, and set up a 6-bit and above management router password in the admin page that appears, and click OK when the setup is complete.
. The following figure:
Note : Please keep this password in mind, the subsequent login Router admin interface needs to log in with this password, if you do not remember, you can only restore factory settings.
4
, set the Internet parameters
Access to the router management interface, the router will automatically detect the Internet, such
as the detection of
broadband dial-up Internet access , in the corresponding settings box to enter the operator to provide the broadband account number and password, and to determine the correct password entered the account, click
Next . The following figure:
Note : If the router detects dynamic IP or fixed-IP internet access, set it up according to the page prompts.
Note : 76% users because of the broadband account password error caused no access to the Internet, please carefully check the broadband account password is correct, pay attention to Chinese and English input, letter case, suffix, etc. whether the input integrity.
5
, set Wireless parameters
Set the wireless name and wireless password.
Wireless name is recommended to use a combination of numbers or letters, do not use Chinese,
wireless password recommended set 8~63 digit and letter combination, click
next . The following figure:
Please power the Extender on (plug in the power outlet, one or more). Click
next , as shown below:
The router starts scanning the extender, and when the Extender is scanned, click
Join and
complete the setup. The following figure:
Possible problems: What to do if the
Extender is not scanned?
Setup complete, as shown in the following figure:
At this time need a mobile phone reconnect modified wireless signal (router and extender issued the signal name is the same), connect successfully can access the Internet.
If you have other computers need to surf the internet, use the network cable directly to connect the computer to the router or the expansion of the LAN port can access the Internet, if it is a notebook, mobile phone and other wireless terminals, connect the wireless signal on the Internet,
do not need to configure the router .
