The wireless extender is a Wi-Fi signal amplifier, which is used to enhance and enlarge the weak signals of existing wireless routers in your home (or in other scenarios, this gives signals to all corners.
Before using the extender, you need a wireless router (or all-in-one machine) that can access the internet. This is the prerequisite for expansion. As shown in the following figure:
This paper introduces how to use mobile phone to operate TL-WA832RE to enhance the wireless signal.
You can also refer to the setting guide video:
Plug the expansion device into a power outlet in a proper position, and connect the mobile phone to the wireless signal of the expansion device. Default extended signal:
TP-LINK_RE_XXXX
Where
XIndicates the last four digits of the MAC address. You can view the MAC address on the extension housing tag.
Note:If the default signal is not found, it may have been set as a relay. Reset the extensioner.
1
, Enter or scan the management address
Enter the address manually:Open the mobile browser, clear the address bar, and enter
Tplogin.cn, Click to log on:
Scan the QR code in the browser:Use a browser with a scanning tool to scan the QR code of the extended housing to log on:
Note:
The QR code of the extender cannot be scanned by WeChat.. Only some browsers support code scanning, such as UC, QQ, Baidu, and cheetah.
Unable to log on to the extended interface. What should I do?
2
, Set the management password
After the browser displays the extended login box, set 6 ~ 15-bit management password. This password will be used to log on to the management extender later. Remember to click
Login, As shown in the following figure:
1
, Automatic scanning signal
After logging on to the interface, the extended will automatically scan the peripheral signal, as shown below:
2
Select the wireless signal to be extended
Note:In this article, the extension of zhangsan is used as an example. You need to select the signal to be extended.
3
Enter the wireless password
Enter the wireless password for the extended signal and click
Next Step.
4
, Wait until the extension is complete
The page prompts that the expansion is in progress. The mobile phone will disconnect the wireless connection with the expansion device, as shown in the figure below:
Now, the scaling operation settings are complete. Let's confirm that the scaling is successful.
Try to observe the extended indicator. If it is green or orange, the expansion is successful, as shown below:
Tip: OrangeIt indicates that the expansion device is too close to or too far from the master router. You can adjust the location as appropriate.
In this case, the default signal of the extended router disappears and has become the same as that of the primary router. The Wireless name and password are the same. Your mobile phone can connect to the Internet with the extended signal.
