Toilet waterproof material

Waterproof bathroom Materials Purchase

The main reason for water leakage is that the waterproof coating used is unqualified, so the purchase of waterproof coating is particularly important. Currently, there are two categories of waterproof materials on the Mall: Polyurethane Waterproof Coatings and polymer cement-based waterproof coatings. Polymer cement-based systems have become the main character of Waterproof Coating malls. the waterproofing of polyurethane was once the main waterproof function of the waterproof mall. Now, the reason is that it is not environmentally friendly. cement mortar is one of the new waterproof materials, is the appropriate fire information currently sold. General waterproof materials are recommended for kitchen and bathroom waterproofing. The earliest and largest use of acrylic acid is environmental paint and paint.

Waterproof toilet construction technology, process and precautions

Before the bathroom decoration construction, we must first determine the planning of the water circuit. We must carefully consider the possibility, feasibility and availability of the planning scheme. First, laying and leveling the water, electricity, and heating pipes.

When waterproofing the bathroom, the underlying layer should be handled first. Remove the original decorative materials, clean the float and cement, flatten the ground with cement mortar, and then use waterproofing. The demand is smooth and dry. This will prevent leakage of waterproof coatings due to uneven thickness. Apply even when pasting waterproof coating. Do not have the appearance of leaking brush, drum and shedding. The thickness of the waterproof coating layer shall not be less than 1.2mm. Otherwise, the waterproofing effect will be affected. During the construction, pay attention to the waterproof dead corners. the seams between the wall and ground, as well as the joints between the upper and lower pipes and the ground, are the most common problems in the local area.

After the construction of the waterproof layer of the bathroom is complete, all the sewers in the bathroom are blocked, A 25cm high hurdle is built at the door, and 20cm high water is poured into the bathroom. After 24 hours, check whether there is any leakage appearance on the wall and ground around the wall. If the leakage demand is repaired in time, repair the wall and then perform 24 hours of water test without leakage before entering the next stage of construction. After the water shielding experiment is complete, the general requirement is 5-7 days (the waterproof coating constitutes the waterproof membrane requirement 5-7 days), and a layer of cement mortar maintenance layer is created on the waterproof coating layer, one is used for maintenance of the waterproof coating layer, and the other is used to facilitate the pasting of tiles. Pay attention not to damage the waterproof coating layer that has been prepared.

After the cement mortar maintenance layer is dry, it can be pasted with wall tiles, spray paint, or anti-wallpaper for normal decoration.

Hong Kong zhongrui waterproof material reminder: In general, according to the above process made out of the toilet waterproof decoration project, the waterproof effect is very good!

Toilet waterproof material