Tp-link Router Lan-wan cascade how to set

the method of Tp-link router Lan-wan cascade setting

Before setting, please reset the router (Restore factory settings).

Reset method: Under the power state, long by the router reset key more than 5 seconds to loosen, reset successfully.

The first step, the computer to connect the wireless router

Follow the figure below to connect the computer and the Cascade router, as shown below.

Open the IE browser on your computer, enter the admin address (192.168.1.1 or tplogin.cn) and log in to the router management interface.

Step two, set up the wireless router

After you log in to the admin interface, make the following settings.

1. Set Wireless parameters

Click Wireless Settings >> wireless security settings, modify the SSID number, recommend that you set any combination of letters or numbers, do not use Chinese or special characters. Click Save.

Note: The setup process does not need to reboot the router, waiting for the settings to complete the reboot so that the settings take effect.

Click Wireless Settings >> Wireless security settings, select WPA-PSK/WPA2-PSK encryption mode, in the location of the PSK password set the wireless password, click Save. Do not reboot and continue with the next setting.

2, modify the management IP address

Check the admin address on the back of the router and if it is tplogin.cn, you do not need this step.

Login Router management interface, click Network Parameters >> LAN port settings, modify LAN port IP address and front-end network is not the same network segment (take 192.168.0.1 as an example), save, Router prompts restart, click OK.

Note: The different network segment that is the front-end is 192.168.1.1, only need to modify the third number can, such as modified to 192.168.0.1, 192.168.3.1, etc., after modification, need to use the modified address management router.

The router prompts for a reboot and tries to surf the internet after restarting.