TP-LINK router settings make shared Internet access more convenient

Vro achieves Internet sharing

Currently, the use of home broadband is divided into several homes by a single broadband, and the speed is enough. In order to save some money, we can share the Internet. Several people use the same ADSL line, this requires a router, the following I will take the TL-R402 router, for example, with the illustrationTP-LINK router settingsMethod.

TP-LINK router settings detailed steps:

Layout the route well. The Internet, which is the main line of ADSL, is connected to the WAN port of the route. The LAN port is connected to the computer Nic you need to access the Internet. Each router has a default IP address, check out the manual and you will find out, my 192.168.1.1; configure your computer IP address as 192.168.1.x, And the gateway and dns point to the vro, that is, 192.168.1.1; as follows:

Open InternetExplorer on the computer, enter http: // 192.168.1.1/, enter the TP-LINK router settings interface;

Here prompt to enter the user name and password, the default user name and password are admin, on the router specification also has written. Enter and press enter, you can enter the TP-LINK router settings interface.

Note:TP-LINK router default IP is basically 192.168.1.1 password is admin

First go to The TP-LINK router settings to see:

Here we select the setting wizard. Please see the picture

We select adsl virtual dialing here. Most of us choose it. The other static data is selected by the leased line. We will not detail it here. We know broadband users, tietong, China Netcom and other virtual dialing users, select it, and then click Next.

After clicking Next, select the last step to complete the router settings. You can also set it directly without using the wizard. Select network parameters in the left-side navigation pane of the router. → WAN port settings

Finally, save and restart the route once. All the settings have been completed. Because the configuration of each vro is a principle interface, it will not be very different. Generally, this tutorial can be completed,

Note:

TP-LINK router settings content is introduced, here we want to remind the majority of users, because the DHCP service of this router is automatically started, so you just need to connect to the PC computer, the vrodhcp will assign an IP address. If DHCP is enabled, return to the first figure above and select automatically obtain DNS and IP. In addition, if you are using the DHCP + dial-up mode in some regions of Henan Netcom users, you can also set the long NIC address in the route to use the route connection normally.