Tp-link Router Wireless signal intensifier how to set up

Tplink Router Wireless Signal intensifier setting method

The main router should be connected to the network, and the auxiliary router can surf the internet without a wire. The first is to set the main road, with a notebook connected to the main router to open the browser, in the Address bar to enter 192.168.1.1 if the IP address has been modified to use the modified login.

2 in the Login interface input username and password, if modified to use modified, did not change the original account and password--admin

3 Login to the main router interface, select "Wireless Settings" under "Basic settings", modify the SSID can be added in the following a on the line, easy to identify. Select 11 in Channel, others are OK but the secondary router should be consistent with the main router, complete click "Save"

4 Set Password, choose "Wireless Settings"--"Wireless security Settings" Select WPA2-PSK encryption, enter the password you want to set, complete the point "save"

5 Set up the DHCP service, select Enable and save

6 Modify the IP address to prevent conflict with the secondary router address. Click "Network Parameters"--"LAN Port Settings" Modify IP address to 192.168.1.1 and then "save"

End

Method/Step 2 sub-router settings

Login to the secondary router, modify the IP address, click "Network Parameters"--"LAN Port Settings" Modify IP address to 192.168.2.1 and then "save" restart and then log on again.

Set password, choose "Wireless Settings"--"Wireless security Settings" Select WPA2-PSK encryption, enter the password you want to set, complete the point "save." Same as the primary router Setup method

By selecting Basic settings under Wireless settings, modifying the SSID can be done by adding a b at the back, which is easy to identify. In channel, select 11 to set the same as the primary router. Then click "Open WDS" and click "Scan"

Scan complete Popup New window, find main router ID click "Connect"

Enter the password for the primary router, click "Save"

Set up the DHCP service, select "Do not enable" and "save", and the secondary router does not have DHCP enabled. At this point, the secondary router has successfully established the bridge function with the main router.