Tp-link tl-wdr6300 5G Wireless WDS bridging mode how to set up

set Tp-link tl-wdr6300 5G Wireless WDS bridging mode Step one, view the main router information

Enter the settings interface of the master router (the router that is already connected to the Internet) to view the wireless signal name (SSID), encryption mode, wireless password, channel parameters of the primary router, as shown in the following illustration. Ssid. zhangsan_5g Wireless Encryption method. WPA-PSK/WPA2-PSK wireless password. 1A2B3C4D, wireless channel. 157

Setting Tp-link tl-wdr6300 5G Wireless WDS bridging mode Step two, tl-wdr6300 router WDS bridge settings

1, in the Tl-wdr6300 settings interface, click "Wireless Settings 5GHZ"--> "Wireless basic Settings"--> "SSID" modified. Zhangsan_5g--> "Channel" selection. 157 (consistent with the main router's channel)--> check "Open WDS"--> click "Scan".

2, in the results of the scan of the main router ssid:zhangsan_5g--> and then click on the "Connection" can be, as shown in the following figure.

Warm tips. If the WiFi name of the primary router is not found in the scan results, check to see if the wireless feature is turned on on the primary router and place the primary router and the tl-wdr6300 router in a closer position.

3, after clicking on the connection, the following settings interface will appear, "Key Type" selection. Wpa-psk/wpa2-psk--> is completed after "key". 1A2B3C4D (wireless password for the main router)--> click "Save".

4, set the tl-wdr6300 wireless password

Click "Wireless Settings 5G"--> "Wireless security Settings"--> select "Wpa-psk/wpa2-psk"--> in "PSK password" fill in. 1A2B3C4D (the same wireless password for the main router)--> click "Save".

5, shut down the tl-wdr6300 router DHCP. Click "DHCP Server"--> "DHCP service"--> Select "Do not enable" after "DHCP server"--> click "Save".

6, modify the tl-wdr6300 router LAN port IP address. Click the "Network Parameters"--> "LAN Port Settings"--> "IP Address" modified to. 192.168.1.2--> "Save".

Pay attention to the problem. If the previous router's setting URL is 192.168.0.1, then the LAN port IP address of the tl-wdr6300 router should be modified to. 192.168.0.2, this point please the broad masses of netizens attention.

Reboot the router. After clicking Save, the router prompts for a reboot and clicks "OK" according to the prompts.

Warm tips. After the reboot, the user needs to enter in the browser. 192.168.1.2来 Login Router.

Setting Tp-link tl-wdr6300 5G Wireless WDS bridging mode step three, check that the WDS bridge settings are successful

In the browser, enter the TL-WDR6300 router modified LAN port IP address, this article is 192.168.1.2, login to the settings interface.

Click on the "Run status"--> to view the WDS status under "2.4g_ Wireless status" If it is displayed. Successful, the WDS bridging settings were successful.

At this point, the Tp-link tl-wdr6300 wireless router 5GHZ Wireless WDS Bridge Setup was completed, and the wireless terminal connected to the TL-WDR6300 router was able to surf the internet, while in the process of mobile wireless terminal equipment, the automatic roaming between the main and the secondary routers could be realized.