Tp-link tl-wr882n Router WDS bridge how to set

Tp-link tl-wr882n Router WDS bridge setup case

For example, users need to prepare 2 tl-wr882n routers, for the convenience of identification, we mark the main router A and Vice Router B, where the primary router A connects the Internet,wds Bridge network topology as shown in the following figure.

Friendship description. In practice, the main router A and the sub-router B brand and model can be different, but also can establish a WDS bridge, configuration method is not significant.

Primary Router a configuration

1, in the TL-WR882N settings interface, click the "Wireless Settings"--> "Basic Settings"--> set "SSID number", note the SSID do not use the Chinese--> "channel" choice. 1--> Check "Open wireless function", "Open SSID Broadcast"--> click "Save".

Attention. Keep in mind that the channel selected here is 1.

2, click "Wireless Settings"--> "Wireless security Settings"--> select "Wpa-psk/wpa2-psk"--> set "PSK password"--> Click "Save" below.

Sub-router B setting

1, change LAN port IP. Click the "Network Parameters"--> "LAN port Settings"--> change the IP address to be different from the primary router (recommended as the same network segment). Modify to complete click Save, pop-up OK page Click OK, wait for reboot complete.

2, restart after the completion of the installation of the secondary router B interface, click the "Wireless Settings"--> "Wireless basic settings"--> check "open WDS"--> and click "Scan."

3, find the main router a "SSID"--> click "Connection."

4, set the "channel" of 1, and the main router a channel the same--> "key type" selection. wpa-psk/wpa2-psk--> in "password" to fill in the main router a wireless connection password--> Click "Save."

5. Turn off the DHCP service. Click on the "DHCP server"--> "DHCP service"--> "DHCP server" option in the Settings screen. Do not enable--> click "Save".

Check to see if the WDS bridge was successful

Click "Run Status" on the secondary router B to see "WDS status" under wireless status, and if the display succeeds, the WDS bridging settings are successful.-->