TP Mini Application Introduction-Network Access-Ethernet static IP address access mode

in some enterprises and institutions, the family environment,TP mini need to connect through the wired and set static IP address way to access the front-end network. Below we take TP mini Big Eye Series as an example to introduce the physical wiring and the setting method.  

as shown, connect the TP mini to the front wire .

the following describes TP Mini Ethernet Static IP Address the method of setting up the access network.  

1. turn on Ethernet

Go to " settings ", click Select " Ethernet ", enter the Ethernet setup interface, and " Ethernet " on the hook.

2. Open Static IP

Click " static IP settings ".

Select open to open the static IP.

3. Input Network parameters

Fill in the corresponding input box with the network parameters provided by the operator or unit ( or the network parameters required for the Internet in the home ) , and click OK.

Note: The length of the network prefix is the subnet mask, in the figure is 255.255.255.0, in theactual use may also use other subnet masks, such as :255.255.0.0 .  

thus far, static IP setting is complete, you can see the network parameters we set earlier.