Tplink cannot log on to the extended management interface by scanning the QR code. What should I do?

When setting the wireless extender, you cannot log on to the management interface after scanning the QR code on the housing of the extender using a mobile phone or other mobile devices.

Please refer to the following methods for troubleshooting.

Mobile phone, Pad, and other signals that need to be connected to the extended device to log on to the interface normally. Connect the extended signal according to the current status of the extended device according to the corresponding operation:

Before Expansion Indicator light is Red

1 , Please reset the extended first Reset method:When the power is on, use a sharp object such as a paper clip, press and hold the RESET key at the bottom of the extended device for 5-8 seconds, and the indicator will flash three times until it turns on normally. The RESET is successful. 2 , Connection extended signal The default signal name for the extended is: TP-LINK_RE_XXXX (X represents the last four digits of the MAC address), which can be viewed on the bottom of the extended tag.

After the extension is successful Indicator light is Green, Orange

1 , Please first power off the master router 2 , Power-off restart extended device 3 And connect the wireless signal of the extended device. The signal of the extended device is the same as that of the primary router by default. If you have a wireless name of the extended device, connect to the new one.

The QR code of the extender currently does not support WeChat or mobile phones QQ , Mobile Baidu, etc. APP SCAN function

Only browser scanning is supported. Web browsers that support scanning include UC Browser, QQ browser, and Baidu Browser.

If you still cannot log on after following the instructions above, try to connect to the extended device signal and manually enter tplogin.cn