Tplink Router wdr8500 How to set up a wireless bridge

Tplink Router wdr8500 set up wireless bridge connection analysis

Primary and secondary routers through the wireless bridge, wired, wireless terminals can connect the main and secondary routers online, the mobile process can be automatically switched to achieve roaming. Topology is as follows

Attention

1, primary and secondary routers do not connect network cable;

2, dual-frequency routers can not be carried out at the same time 2.4G and 5G Bridge;

3, WDS Bridge only need to set up on the secondary router, the following operations are performed on the secondary router.

Tplink Router wdr8500 set up a wireless bridging method

First step, enter Bridge application page

1, into the management interface

The computer connects to the secondary router's LAN port or wireless signal, opens the browser, empties the address bar and enters the tplogin.cn login management interface.

2. Enable Bridge application

Click application Management, as follows

Find wireless bridge, click to enter

Step two, follow the Bridge Setup Wizard

1. Start Setup Wizard

When you enter the Wireless Bridging Setup Wizard, click Start settings as follows

2. Scan Wireless Signal

Routers automatically scan peripheral wireless signals

3, select the main router signal

Select the main router signal to scan and enter the main router's wireless password and click Next

Note If you do not scan the main router signal, verify that the primary router is switched on and try to reduce the distance between the primary and secondary routers.

4. Confirm Admin IP Address

The primary router assigns an IP address to the secondary router for subsequent management of the router, and it is recommended that you write down the IP address and click Next.

5. Set up the wireless password of the auxiliary router

Set the wireless network name and wireless password for the secondary router 2.4G signal, click Next, as follows

Note the wireless parameters of the secondary router can be set to be inconsistent with the primary router, but you must remain unchanged if you want to implement wireless roaming.

Step three, confirm bridge success

Once again into the application management >> Wireless bridge, you can see that the bridge status is bridged successfully. As follows

This wireless bridging (WDS) Setup completes, the wireless terminal connects the Zhangsan, the wired computer connects the main, the auxiliary router's LAN port to be able to surf the Internet. In the process of terminal movement, automatic roaming between main and secondary routers can be realized.