Tplink: how to set and modify the password of a wireless router and wireless network card

1. How do I set a wireless network password for a new wireless router?

1. Connect the vro to your computer through a network cable and obtain the IP address and logon account and password of the vro from the labels at the bottom of the vro. As shown in the following figure:

2. Open a browser, enter the IP address of the router in the address bar, and enter the account and password in the pop-up logon window, as shown in the figure below:

3. After logging on to the vro, click "wireless parameters"> "basic settings" on the left side of the window to open the "basic settings for wireless networks" interface. As shown in the following figure:

You can set the connection name of the wireless route in the SSID.

Check "enable security settings" (number 4), select "security type" as "WPA2-PSK" (number 5), enter the wireless password (number 6), it is recommended to set a more complex password, the simple password is easy to crack and can be saved at last.

2. How do I change the wireless network password of a configured wireless router?

Is changing the wireless network password of a set wireless router different from that of a new router?

In fact, the specific operation method is the same. The only difference is that the IP address and password of the management account may be changed because the vro has been set. Therefore, you must obtain the correct IP address and management account password before performing the operation.

Method 1: first connect to the vro, and then check that the IP address of the Gateway connected to the network is the IP address of the vro. If you have a multi-level router, we recommend that you disconnect the upper-level router before performing the operation. After obtaining the correct IP address, follow the above steps.

Method 2: If the Gateway cannot be obtained. For example, DHCP is disabled when it is used as a secondary route or AP. Or forget the logon account and password. In this case, we recommend that you reset the vro and then set it again using the new vro setting method.

RESET a vro: Generally, the vro has a RESET button or a small hole next to the network cable interface. Press and hold it down (if it is a small hole, you need to take a toothpick or the like, when all the lights on the front panel of the router are on at the same time, release the router.

Note: reset the vro to clear all the settings. Before performing this operation, make sure that the network information is saved, such as the ADSL account and password.

3. How can I modify the wireless network password of a wireless network adapter after the wireless route password is changed?

Take Windows 7 as an example. When the wireless route password changes and the SSID remains unchanged, Windows 7 tries to connect with the previously saved password and cannot connect successfully. Therefore, we need to re-modify the wireless network password stored in the system. The procedure is as follows:

1. Right-click the wireless connection icon in the system tray in the lower right corner of the system to open the network and sharing center;

Click "wireless network connection ";

In the pop-up "wireless network connection status", click "wireless properties" and click the "security" tab in "wireless connection properties, enter a new password in "Network Security Key.

2. Click the wireless connection icon in the system tray in the lower-right corner of the system. In the wireless connection list, find the connection to change the password, right-click the connection, and click "properties ", in the pop-up "wireless network connection status", click "wireless properties" and click the "security" tab in "wireless connection properties, enter a new password in "Network Security Key.

3. Right-click the wireless connection icon in the system tray in the lower right corner of the system, open the Network and Sharing Center, click "Manage Wireless Network" on the left, and double-click the connection to change the password, click the "security" tab in "wireless connection properties" and enter a new password in "Network Security Key. You can also delete the wireless connection, reconnect, and enter the new password as prompted.