TPlink (TL-TR761 5200L) wireless router Internet settings guide

The following describes how to set up TL-TR761 5200L Internet sharing.

1. Install uimcard

Open the SIM card and memory card slot lid on the side of the router, make sure that the metal of the UIM card is down, switch the angle to the slot, push the UIM card into the slot until you hear the sound of "seek. Close the lid of the SIM card and memory card slot and press the power switch for 3 seconds to start the router.

 

2. Connect to the wireless network

To log on to the Web management page of the vro。, you must first connect to the wireless network of the vro. The computer searches for the vrossid SSID (wireless network name) through the wireless network card ). The default SSID of the router is the TL-LINK_3G_XXXXXX (the last six digits of the MAC address), the MAC address can be viewed on the tab on the back of the router. Double-click the wireless network name. When the connection is displayed, the computer can obtain the IP address assigned by the router.

3. Set the vro through the setting Wizard

Open the browser and enter the management IP address of the router in the address bar of the browser: http: // 192.168.1.1. The vro logon interface is displayed. Enter the logon password. The default logon password is "admin ".

On the connection status page, click the setting wizard on the top menu bar.

Go to the Settings Wizard settings page and click next.

On the dialing settings page, select the dialing mode as needed and click next.

Set the dialing parameters on the dialing settings page. Enter the dialing information provided by the ISP and click next. We recommend that you keep the default configuration. If you are not clear about the configuration, contact your ISP.

Click next to set wireless parameters, the default SSID is TL-LINK_3G_XXXXXX (the last six digits of the MAC address, the password is empty ). To help you quickly find the wireless signal of the vro and prevent network attacks, we recommend that you reset the SSID and wireless password (here you can also set the Wireless name and wireless password that you are familiar, we recommend that you do not use Chinese characters when setting the Wireless name ).

Click next to complete the Settings Wizard settings.

On the complete page, confirm the vro parameters you have just set. Click finish to automatically restart the vro.

4. Reconnect to the wireless network

Because the wireless parameters of the router are modified, you need to re-search the router signal and connect (in this example, the wireless signal is TL-LINK_3G_171509, the wireless password is 12341234 ).

After connecting to the wireless signal TL-LINK_3G_171509, the computer has been able to share the Internet through the TL-TR761 5200L