The primary router and the secondary router use wireless WDS bridging. The wireless terminal can connect the secondary router to access the internet. During the process of moving, the primary and secondary routers can automatically switch between the routers to achieve roaming. The application topology is as follows:
Note:: In actual application, the primary router may be of another model, and this application can also be implemented.
1
, OK
SSID
And fixed Channel
Log on to the management interface of the primary router, and click
Wireless Settings
>
Basic settings, Confirm on this page
SSIDNo.(Wireless Signal name), fixedChannelAnd clickSave.
2
Confirm the wireless password
Click
Wireless Settings
>
Wireless security settingsConfirm the wireless encryption method and password.
1
Disable
DHCP
Server
Log on to the management interface of the secondary router and click
DHCP
Server
> DHCP
Service, Select the DHCP server
Disable, Click
Save.
2
Modify and enable wireless settings
WDS
Scanning signal
Click
Wireless Settings
>
Basic wireless settings, Modify
SSIDNo. Same as the primary router, fixedChannel, SelectEnableWDS, ClickScan.
3
Select the main router signal
On the scan page, find the wireless SSID of the master router and click
Connection.
Note:: If WDS cannot scan the signal of the primary router, make sure that the front-end wireless routing feature is enabled and try to reduce the distance between the primary and secondary routers.
4
, Enter the password
In
Key
Enter the wireless password of the master router, and then click
Save.
5
Set the wireless password of the secondary router
Click
Wireless Settings
>
Wireless security settings, Select
WPA-PSK/WPA2-PSK, In
PKS
Password
Set the same wireless password as the primary router, click
Save.
Note:The SSID and wireless password of the secondary router can be different from that of the primary router. If you want to implement roaming, it must be the same as that of the primary router.
6
, Modification management
IP
Address
Click
Network Parameters
> LAN
Port settingsModify the IP address in the same CIDR block as the primary router. Click finish.
Save, Click
OKWait until the restart is completed.
Note:: Use the modified IP address to log on to the vro management page after restarting.
Open the browser and log on to the management interface through the management IP address modified by the secondary router. Click
Running status, Observe
Wireless status
> WDS
Status, Display
Successful
Indicates that the WDS Bridge is successfully set.
Now, the wireless WDS bridging configuration is complete. The wireless terminal under the secondary router is connected to zhangsan and the network can be accessed normally. When the terminal moves, it can automatically roam between the primary and secondary routers.
