[Turn] no longer disorderly line installed blind diagram teach you to recognize the motherboard pin

1th page: The biggest challenge is to mess up eight bad pins.

The relatively high threshold of the PC DIY to some extent suppressed its development in today's environment, so for just touch pc DIY and interested in PC DIY readers to introduce relevant knowledge becomes very necessary. In the last lecture on "picture commentary to see a guide you know the motherboard on the slot" article, the author has taken everyone to know the motherboard of various types of slots. Many readers say that the slots on the motherboard are actually very well recognized, and many aspects are not mentioned, such as what the pins are, how the lines are plugged, etc. The author in the previous said that the popularization of knowledge is starting from scratch, and the complexity of PC DIY is never possible just through an article for you to explain clearly. Recognize slots is the most basic knowledge, monkey anxious everyone, today we will come to see

Recognizing slots is the first step for a novice pc DIY user, but the installation is not the easiest thing to do with all the hardware plugged into the motherboard: The CPU needs a heatsink, and the heatsink needs to be connected to the motherboard via a wire, and the USB port on the chassis needs to be connected to the motherboard via a wire. The headphone and MIC interfaces on the chassis panel need to be connected to the motherboard via wire, and the boot and restart lines on the chassis also need to be connected to the motherboard ... Wait too much, and where exactly are these lines plugged in? What are the various pins on the motherboard for?

Today, I take everyone to recognize a motherboard on the various types of pins what is the length of what, and tell everyone what they are doing, so that you no longer for the chassis of a messy line and headache.

2nd: Switch Restart front panel What's all the stuff?

Switch reboot front panel a bunch of what are they?

One of the keys we use every day on our computers is the power-on button on the chassis ... Restart the button, there is no one want to use it frequently. = The switch and restart buttons are very far apart from the motherboard, and the ones that connect them are the messy lines.

the motherboard's F-panel pins are typically located in the southeast corner of the motherboard

In the southeast corner of the motherboard is a pin area named F-panel (FRONT Panel front panels). The most typical f-panel is the look of the 5-pin under the 4-pin as shown. above the first two pins for the power-on lights, the latter two for the boot, the lower first two for the hard drive lights, the 3rd and 4th restart, the last is a non-connecting needle .

All we need to do is to insert the corresponding pin on the motherboard f-panel according to the dimensions on the front panel cable of the chassis. Some motherboard brands of the F-panel area may be added other pins, such as buzzer (hereafter mentioned), but original aim, mastered the few pins, the future installation will not for the switch restart and various lights worry about.

only two light pins differentiate the positive and negative poles, and see the sign of the positive and negative polarity marked by the chassis cable.

Special note is that the switch and hard drive light difference between the positive and negative, and switch and restart the PIN is not positive or negative. You must pay attention to the installation of the positive and negative Poles indicated on the chassis cable. What do you say if the outfit is reversed? Seemingly the most serious is the shutdown lights, lights off, the situation is heavier I do not know ... In short, this distinction between positive and negative do not install the reverse is good!

[Turn] no longer disorderly line installed blind diagram teach you to recognize the motherboard pin