Typical Example of a layer-3 Switch related to VTP single-arm Routing

 

 

 

If SW1 is a layer-3 Switch and SW2 is a layer-2 switch, the following requirements apply: vswitch with VTP and SW1 with server SW2 with client R1 F0/0.12 with VLAN12 F0/0.14 with VLAN14 SW1 SVI with 12 14 IP addresses 192.168.12.0/24 192.168.14.0/24 R2 respectively belong to VLAN14, enable network-wide IP address connection for three-tier Devices

The configuration is as follows:

R1

 

R2

 

SW1

 

SW2

 

 

The key to this example is that the connection between VTP and R1 and SW1 must be set to TRUNK !!!

 

 

 

This article is from the "ye Ji" blog