U disk installation system into PE can not find the hard drive how to do?

In fact, the U disk installation system can not find the hard disk, this phenomenon is likely to be hard disk mode is not set up well. So, how do you set it up? Boot into the computer motherboard BIOS, enter the method due to the different motherboard, some press F12, some press F9 or del key, if you do not know to turn on the screen at the top or the bottom of the tip.

After entering the BIOS, enter the CONFIG option, select Serial ATA (SATA), change the original "AHCI" to "Compatibility" or "IDE", and then press F10 to save the settings just now.

If you are just entering the installation interface soon or a blue screen is not prompted to find the hard drive, then more than 90% of the SATA mode may be set up the problem, re-enter the BIOS settings will be good.

If the setting is still not working, then you can check the other issues, such as data cable, open the chassis, the hard drive data cable unplug, and then plug back, reboot to see if you can detect the hard drive, if not, it is necessary to consider whether the hard disk problem, but the general hard drive problems are very small.

With a U disk installation system The most user headaches is the installation process of small problems, so that installation can not continue, if a friend also encountered the above-mentioned situation of this introduction, do not put the reference to this method to try, may help you easily to solve the problem.

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join