USB disk boot can not find a hard drive solution

First of all, your hard drive is larger than 200G, and is stat hard drive, because most u disk PE system on stat hard disk support is not very good, so the situation will occur, the solution is as follows:

1, first after inserting a U disk, boot into the BIOS to modify the settings, view is denied to the U disk, or directly on the boot press F9 or F10, F11 motherboard, setting is not the same as the boot sequence settings, and then use the old peaches or the morning maple u disk start, do not enter the PE interface, directly into the Ghost system Daquan interface After the start of the GHOST11, the other can not start, or have problems, and then load mirror like, direct Ghost.

2, the boot into the PE interface, see if you can see their hard disk, and then the XP image directly copied to the local hard drive, and then from the Kai, with U disk into the DOS interface, manually start ghost, load restore. Enter the BIOS to change the SATA mode

1. After entering the BIOS, enter the "config" page

2. Re-enter the "serial ATA (SATA) page

3. Change the original "ahci" to "compatibility] or [IDE]

Case study: How SATA is set to IDE mode in HP laptop BIOS

Boot into the motherboard BIOS, the SATA in BIOS is set to compatibility (compatible mode) or IDE mode. HP Notebook BIOS entry is F10, as for setting up your BIOS version, set the location is not the same, but the setting method is to set SATA to compatibility mode or ID mode. You can also try to change a SATA hard drive installation disk, or at the beginning of the installation press F6, load Drive, installed after the normal installation. If you install with XP,

A blue screen or just enter the installation interface soon prompted not to find the hard drive 100% is the problem of SATA mode Setup, enter the BIOS settings, or find a comparison of the new version of the Ghost XP installation,

In general, the new version of the Ghost system is directly compatible with SATA mode, if Vista is not the case, unless it is IBM's X200 those machines. At this time just put a Mode Selection "" AHCI to "IDE" → Press "F10" to save the restart on it.

U disk boot can not find the hard drive is mainly by the SATA mode in the blocking, in the SATA mode, limited the launch of U disk, users will only be the SATA mode into the IDE mode to be able to use the normal.