Use Arduino Uno for the Arduino Mini (Pro) Burn program

Prepare for Arduino Mini (Pro) burning program with Arduino Uno

• Arduino Uno
• Arduino Mini (Pro)
• DuPont Line several

Wiring

• First remove the chip on the Arduino atmega328p

• Wiring

  Uno-–mini

  
  0 (Rx) –0 (RX)

  
  1 (TX) –1 (TX)

  
  vcc--VCC

  
  gnd--GND

  
  Reset–rst

The swipe-in program connects the Arduino to the computer

Find the appropriate Arduino board (Arduino pro or Pro Mini) in the tool-and board

Locate the A4 pair port (/dev/tty.usbmodem* or/dev/tty.usbserial* on Mac) in the tool-and port

Input example Sketch (blink)

01.Basic, example, file, Blink

Then click "Upload" in the IDE

When the upload is complete, the Arduino Mini (PRO) light starts flashing

Copyright NOTICE: This article for Bo Master original article, without Bo Master permission not reproduced.

Article Source: http://blog.luoyuanhang.cn

Copyright NOTICE: This article for Bo Master original article, without Bo Master permission not reproduced. (Article Source: http://blog.luoyuanhang.cn)

Use Arduino Uno for the Arduino Mini (Pro) Burn program