Use cygwin to compile CFE

1. cygwin Installation

Note that devel must be installed. Install the editor here.

2. Go to ../CFE/bcm97405a/build

Run the make command or Sde-make to compile a CFE. BIN file under the build directory.

3. Burn and write CFE

1) Put CFE. bin in the/tftpboot/directory.

2) switch the development board to the CFE mode.

3) execute ifconfig eth0-auto

4) Run flash-noheader 10.147.6.11:/zzh/cfe_zzh.bin flash0.cfe.

If you use a U disk to burn to write CFE, the step is to execute Flash-noheader usbdisk0: cfe-zzh.bin flash0.cfe, of course, the cfe-zzh.bin should be placed under the root directory.

4. Restart the Development Board to use the new CFE.