Use Hyper-V to start virtual machine prompt "Unable to start virtual machines ... Order is not running "

Failure phenomenon:

Lenovo after the 8 series K, E, V, B, M notebook computers, such as Zhaoyang E49, V480, and so on, using Hyper-V to establish virtual machines, in the start of the virtual machine prompted "Unable to start the virtual machine ..., because the virtual machine monitor is not running the error message, and thus cannot start." As shown in figure:

Reason Analysis:

Click View details in the previous illustration to see the following figure.

For this machine, 1, 22 items are not a problem.

Solution:

Restart your computer, enter the BIOS Setup, and select Security, Memory Protection:

Set "Data Execution prevention" to "enabied" and save the settings and exit.

Restart the virtual machine again after restarting the computer, solve the problem!

Note:

Other models in case of similar problems, can also refer to the solution.

Little knowledge: About memory protection options

Some computer viruses and worms run code that allows only data, causing a memory buffer overflow. If your operating system can use the data Execution prevention (DEP, Data Execution Protection) feature, select Enabled to protect your computer from such viruses and worms.

If you select ' Enabled ' and you find that an application is not functioning correctly, select ' Disabled ' and reset the setting.