Use Photoshop to pull portrait pictures cool texture dark purple effect (1/2)

< small map view big picture >

Final effect

1, open the original material, the background layer to copy a layer. Enter the channel panel, select the green channel, press CTRL + a all, and press CTRL + C to copy. Select the blue channel, press CTRL + V paste, point RGB channel, and then back to the layers panel, the effect of the following figure.

< map 1>

2. Copy the current layer, add the layer mask, and rub the background part with a black brush. Then create a new layer below the current layer, fill the black, and the effect is as shown below. You can also pull out the characters individually, and then fill the background black.

3, on the top of the layer to create an optional color adjustment layer, red, white, neutral color, black adjustment, parameter settings such as Figure 3-6, the effect is shown in Figure 7. This step is to fine-tune the dark part of the color and turn it into dark purple.

< map 3>

< map 4>

< map 5>

< map 6>

4, create curve adjustment layer, red, green, blue to adjust, parameter settings such as Figure 8-10, the effect is shown in Figure 11. This step adds red and blue to the screen.

< map 8>

< map 9>

< map 10>

5, create brightness/Contrast adjustment layer, appropriate to increase the contrast of the picture, parameter settings such as Figure 12, the effect is shown in Figure 13.

< map 12>

< map 13>

6, create a color balance adjustment layer, the high light adjustment, parameter settings such as Figure 14, determined to retain only the face and skin parts, other parts with a black brush wipe.

< map 14>

7, create a new layer. Press CTRL + ALT + Shift + E-stamped layer. Into the channel panel, the green channel to copy a layer, to get the green copy channel. Use curves and other palette tools to dim the picture and adjust the texture of the face, as shown below. Then press CTRL + A to select all and press CTRL + C to copy.

< map 16>

8, back to the layers board, create a new layer, press CTRL + V paste, and then change the layer opacity to: 30%. With the layer mask, use a black brush to wipe out the face and skin, the effect of the following figure. This step increases the texture of the skin tone.

< map 17>

9, with a pen to check out the lips of the selection, and then create a color balance adjustment layer, slightly fine tuning red, the effect is as shown in Figure 19.

< map 18>

Home 1 2 last page