Using Photoshop to create a soft autumn purple scene character picture tutorial

Original

< small map view big picture >

Final effect

1, open the original material, create hue/Saturation adjustment layer, select yellow, and then use the straw to absorb the background leaf color adjustment, parameter settings such as Figure 1, the effect is shown in Figure 2. This step turns the color of the leaves into orange and yellow.

< map 1>

< map 2>

2, create an optional color adjustment layer, red, yellow, white, neutral, black adjustment, parameter settings such as Figure 3-7, the effect is as Figure 8. This step increases the picture's red.

< map 3>

< map 4>

< map 5>

< map 6>

< map 7>

3, create curve adjustment layer, green, blue adjustment, parameter settings such as Figure 9,10, the effect is shown in Figure 11. This step increases the dark part of the blue.

< map 9>

< map 10>

4, the creation of optional color adjustment layer, red, yellow, white, black to adjust, parameter settings such as Figure 12-15, the effect is shown in Figure 16. This step increases the high light portion of the red.

< map 12>

< map 13>

< map 14>

< map 15>

5, press CTRL + J to copy the current optional color adjustment layer, enhance the overall color, the effect of the following figure.

< map 17>

6, create color balance adjustment layer, shadow, highlight adjustment, parameter settings such as Figure 18,19, the effect is shown in Figure 20. This step is to fine-tune the color of the high light and dark parts.

< map 18>

< map 19>

7, the character face a little color, need to repair a simple. Copy the background layer one layer, press CTRL + Shift +] top. Hold down the ALT key to add a layer mask and rub the face out with a white brush. The effect is shown below.

< map 21>

8, the current mask selection, with a palette tool to fine-tune the color of the face, with the main color fusion can be. The numerical value is determined by itself.

< map 22>

9, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Simple to the upper left corner to add some high light, and then appropriate soft treatment, the general effect of the following figure.

10, create hue/saturation adjustment layer, the appropriate reduction of the full picture saturation, parameter settings such as Figure 24, the effect is shown in Figure 25.

< map 24>

< map 25>

11, create a new layer, blending mode to "filter Color", the foreground color set to: #8C3153, with a brush to the bottom of the selection section to paint the front view. Make sure that the layer opacity is lowered appropriately. This step adds a complementary color to the picture.

< map 26>

Finally, fine-tune the color to complete the final effect.