Using PS to make bursting effect

First the effect chart, the material is a person on the line

The first step: Create a new one you like more than the picture House

Open up the footage and pull it out of your new file.

Step Two: Create a new 50*50 pixel canvas Select all with a rectangular marquee and fill it with black, and then edit-Define the brush preset to make it a paintbrush

Step three: Back to the newly-created picture, create a new layer, and then use the Selection Brush tool to select back the square brush we just made and press F5 to follow the diagram

Step Fourth: When you're done, draw a square in the place you want to burst.

Fifth step: After drawing, press the CTRL key to load the square selection, then select the layer that has the sister to add a mask

After you add a mask, point the square layer of the eye off.

Step Fifth: Select the black mask layer next to the character layer and select the Lasso tool

Select the missing half and fill it with white.

Sixth step:

At this point, you will see the side is very obvious edge, so to create a new layer in the drawing of a few square repeat above will become the next picture

Seventh step: In the construction of a layer selection brush tool, press the ALT key to draw the color of the characters, and then like how to draw on how to draw, after painting the transparency into 60

Finally, choose this on the new layer.

And then you do this and then you choose the overlay.

Category:

• PS Image Processing