VGAInterface15The corresponding interface of the root needle is defined as follows.VGAConnector diagram.
1 Red base color Red
2 Green background Green
3 Blue base color Blue
4 Address Code Id bit
5 Self-Test ( Different definitions )
6 Hongdi
7 Greenland
8 Blue Earth
9 Retained ( Different definitions )
10 Digit location
11 Address Code
12 Address Code
13 Row Synchronization
14 Field synchronization
15 Address Code ( Different definitions )
GenerallyVGAOn the connector, yes1,5,6,10,11,15ID of each API. If not, see the number shown in.
Note: When welding the male head, you must note that the direction is parallel and vice versa.
NormalVGAThe method for wire welding is as follows (D15Welding Method ):
Core line of the Red Line Foot 1
Screen of red lines Foot 6
Green Wire Core Foot 2
Green line screen Foot 7
Core line of the Blue Line Foot 3
Blue Line Shield Foot 8
Black Line Foot 10
Brown Line Foot 11
Yellow Line Foot 13
White Line Foot 14
Outer shield D15 End shell crimping
If no interface or line is marked in the preceding table, leave it blank and only solder the interface and line color marked above.
In the actual welding operation, only six wires are used, namely three signal lines (red, green, and blue). The three ends of the signal line are connected to the signal ground line, the other two are the line-to-field synchronization signal line. The computer test is absolutely OK!