Virtual Box installation process (after uninstalling VMware)

VirtualBox
Pre-Installation actions: (perhaps some operations may not be useful, but I did so, and finally the installation was successful)

Step one: Stop all previously installed VMware services (you do not need to do this if you have not previously installed the virtual machine software)
VMware Authorization Service
VMware DHCP Service
VMware NAT Service
VMware USB Arbitration Service
VMware Workstation Server

Step two: In the window run bar, enter regedit, modify the network parameters
Hkey_local_machine\system\controlset001\control\network
Change the value of the AB (default) REG_SZ to 20 (it is a decimal number)

Step three: Start the service within the two services
[1] Device Install Service
[2] Device Setup Manager

Step four: Installation can be
Open the Virtualbox-4.3.8-92456-win.exe file as an administrator for installation

************************************************************
"Note":
1. Must be opened by the administrator mode;

2. During the installation process, the device Setup Manager inside the service stops automatically and requires a prompt discovery of manual startup.

Virtual Box installation process (after uninstalling VMware)