Virtual machine Redhat Bridge cannot get IP address

Virtual MachinesRedhatno access to bridgeIpAddress

first confirm whether the installation is simultaneous VirtualBox and VMware, this scenario only applies to this type of failure with two virtual machines

Error code:

[Email protected] ~]# ifconfig

Eth0 Link encap:ethernet Hwaddr00:0c:29:bd:65:c8

Inet6 ADDR:FE80::20C:29FF:FEBD:65C8/64 Scope:link

Up broadcast RUNNING multicast mtu:1500 metric:1

RX packets:0 errors:0 dropped:0 overruns:0 frame:0

TX packets:45 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:0  (0.0 b) TX bytes:11502 (11.2 KiB)

Lo Link encap:local Loopback

inet addr:127.0.0.1 mask:255.0.0.0

Inet6 addr::: 1/128 scope:host

Up LOOPBACK RUNNING mtu:16436 metric:1

RX packets:18 errors:0 dropped:0 overruns:0 frame:0

TX packets:18 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:0

RX bytes:1392 (1.3 KiB) txbytes:1392 (1.3 KiB)

[Email protected] ~]# ifup eth0

Active Connection Status: active

Active connection path:/ORG/FREEDESKTOP/NETWORKMANAGER/ACTIVECONNECTION/4

* * (process:2677): WARNING **:_nm_object_get_property:error getting ' state ' for/org/freedesktop/networkmanager/ ACTIVECONNECTION/4: (+) Method "Get" with signature "ss" on Interface "org.freedesktop.DBus.Properties" doesn ' t exist

Status: Unknown

Error: Activation connection failed.

[Email protected] ~]#

Workaround: Open Edit in VMware-- Virtual network editor -vmnet automatic settings after information - remove Virtualbox host-only Ethernet Adapter Pre-check OK to save

and then landed Redhat # ifup Eth0

To restart the network card :

[Email protected] ~]# ifup eth0

Active Connection Status: active

Active connection path:/ORG/FREEDESKTOP/NETWORKMANAGER/ACTIVECONNECTION/9

Status: Active

Connection is activated

[Email protected] ~]#

This article is from the "Summer Fun Blog" blog, be sure to keep this source http://firstxiatian.blog.51cto.com/7601637/1886943

Virtual machine Redhat Bridge cannot obtain an IP address