Virtual Private Network router and client settings of golden Wave

The vrovpn's VPN penetration function does not mean that the vrovpn is competent to establish a VPN, it means that it can run the VPN tunnel created by other devices.
1. All vrouters on the vro side support IPSec, PPTP, and L2TP VPN penetration. By default, no vro settings need to be modified, if the VPN cannot be used after the vro is installed, follow these steps.
(1) If the VPN device supports NAT penetration, enable this function, and contact the network administrator to help you complete the VPN configuration, some settings require the permission to be configured through the line. (2) If L2TP penetration is used and the MAC address of your computer has been registered, register the MAC address of the Golden wave router again. Www.2cto.com (3) Open the kinglang router port ing. The IPsec VPN ports are 50, 51, and 500, the pptp vpn port is 1723, And the L2TP port is 1701, the VPN application may use ICMP data packets, so you need to map them.
2. Client (1) only one IPSec client can be installed on the computer. If you have checked and installed other client software, you must delete the original program and reinstall the VPN Client of the Golden wave router, restart your computer. (2) The default SA Lifetime in the kinglang VPN Client is undefined, if your VPN tunnel is frequently interrupted after it is established, you can set it according to the SA parameter value of the VPN gateway connected to the client. (3) If the firewall is enabled on the computer, the VPN Client may not be able to establish a VPN connection. Disable the firewall and try to connect. (4) If the shared resources cannot be accessed through the lan ip address after a VPN connection is established, make sure that all firewalls are disabled on the accessed computer. The above is a common problem in the VPN connection of the Golden wave router. If such a problem occurs, the netizens can try to solve it. This article is from