VLC multicast and receiving

Set up Multicast Server

Step 1: RunProgramThen select "media-streaming ";

Step 2: click Add to select the file to be played (take the WMV file as an example) and click stream ";

Step 3: set three parameters for stream output: source, target, and option. The source has been specified just now. Click "Next ";

Step 4: Select "display locally", select "RTP/MPEG transport stream", and click "add ";

Step 5: if an IPv6 multicast server is created, enter the multicast address ff15: 1, specify the port number "5004", and click "Next" in the lower right corner ". To create an IPv4 multicast server, enter "239.1.1.1" in the address bar (239.0.0.0/8 is the address of the Local Management Group );

Step 6: Set TTL to 10. Click "stream" in the lower left corner to send the multicast video and play it locally (the video is slow to start and takes about half a minute );

Step 7: Use Wireshark to capture packets.

Set up multicast Client

Step 1: run the program and select "media-enable Network streaming ";

Step 2: Enter the URL (RTP: // @ [ff15: 1]: 5004) and click play to watch the multicast video. If it is an IPv4 multicast environment, enter RTP: // 239.1.1.1: 5004.

Note: Disable the PC firewall before testing to avoid affecting the sending and receiving of multicast packets.

========================================================

The above technology can be used to simulate"Ip hd camera data transmission process
".