VMware install Kali Linux system to USB stick boot error (Initramfs:) Fix method

This error occurs after installing Kalilinux to the USB flash drive:

This is the wrong grub path.

Workaround:

In this mode you can enter the command: Blkid to see the listed disks find your USB drive system type= the "Ext4" area to write down the name/DEV/SDC1. (Each person's different may be sdb1 below with SDC1).

And then it restarts.

To the Kalilinux Start screen:

Press the keyboard ' E ' key to enter edit mode:

Locate the word "Initialize memory disk ..." to find a line of Linux behind it ..../dev/sda1 ro changed to/DEV/SDC1 rw, RO changed to RW by F10 reboot to start the boot up again.

If the above operation is correct, you can enter the system successfully. User name: root password: set when you install.

Entered the Kalilinux is a success of 99%, completed the next 1%.

But the above setup method is only temporary change every time.

Permanent action method:

Open the terminal after entering the system.

/Input # GRUB-INSTALL/DEV/SDC #把grub安装到你的u盘, It's a USB drive, not the main area, SDC, no numbers .#update-grub #更新下grub. cfg#cat/boot/mnt/grub.cfg #这一步 If it fails, please do not care too much. You can manually go to the CD and boot down to find the/boot/grud/directory using cat GRUB.CF G Look at the content to see if Linux is mounted on SDC1 (everyone is different). (It may not be shown here that SDC1 may be SDC1 's UUID can be viewed with the Blkid command.) #sync #确保写入 #reboot #重启系统 should be no problem. Resolved. Contact qq:1930932008 If you have any questions

VMware install Kali Linux system to USB stick boot error (Initramfs:) Fix method