VMware Virtual Machine client is Linux in case client ping VMware Gateway, ping impassability __linux

VMware Virtual machine client is Linux in case of client ping VMware Gateway, ping impassability case,

Host the author here is the use of Win7, the host firewall can be closed.

Added: (The network adapter will come out two more------> VMnet1 and VMnet8) after the VMware virtual machine has been successfully installed

As shown in the figure:

VMnet1 is used for host-only mode (host-only).

VMnet2 is used in NAT mode.

Here's a chat VMnet1.

The IP address and subnet mask here are specified by themselves. The author is set up here separately for 192.168.80.1 and 255.255.255.0.

Here the 192.168.80.1 will be the Linux virtual machine configuration IP address, the need to configure the gateway address.

The IP address and subnet mask you set up here can be seen on the host-----> cmd ipconfig, as shown in the following figure.

The Ethernet adapter shown in the figure is VMware network Adapter VMnet1: The IP address and subnet mask are the same as they were made.

Then go into the Linux virtual machine to set the IP address, subnet mask and gateway.

Set the Linux virtual machine as shown in the picture ...

To ping 192.168.80.1 (that is, the IP address set by your VMNET1 network card on the host) this Gateway ... The ping was found to be out of communication.

At this point, the host firewall can be turned off.

The host can also ping Linux virtual machines at this time.

You can see the host ping the Linux virtual machine (192.168.80.101 is the IP address you set up, you can change, as long as within the same network segment can be)