Vmwarevm quick connection using Bridge Mode

Vmwarevm quick connection using Bridge Mode

Setting the vmwarevm to a bridge to access the Internet is equivalent to connecting your host machine and virtual machine to a switch on the same LAN. Once you understand this principle, the remaining problems are:

In the virtual machine settings, select to use:

Custom: Specific virtual network, Vmnet0 (Bridge Mode)

In the virtual network editor of a VM, bridge Vmnet0 to the network adapter that can be connected to the network:

For example, if you use a wired network, you can select a wired network card. If you use a wireless network card, you can select a wireless network card.

Disable the firewall and 360 security guard of the host machine:

The reason is very simple. Generally, these software blocks the network traffic of your virtual machine, which will cause the virtual machine to fail to access the Internet through the bridge mode.

Under normal circumstances, the above settings will enable the virtual machine to be in a real network. If not, the rest will be the network troubleshooting problem, it is recommended that you learn about the basic CCNA to help you understand network communication. It is not a problem to correct the errors in the natural network. In addition, if you understand the network and especially the routing and switching technology, it is just as awesome for development.

This article permanently updates the link address: