Warning: Skipping non-radio button in group

VC cainiao blog, original address: http://henryfu2005.blog.163.com/blog/static
/82079657200852904630294/

Symptom: When we add a group of radio buttons and set them as a group of mutex buttons, and then add other controls, press F5 to compile and the following warning message is displayed:
Warning: Skipping non-radio button in group.

Cause: This warning tells us that the compilation system skips the non-single button (in the same group as this group of mutex buttons. In fact, when we select the group attribute of a control
Controls are regarded as the same group of controls, unless the next control with the group attribute is configured. That is to say, we put the controls created after the single-choice button in the same group, and these controls
Is a non-radio control.

Solution: although this warning does not affectProgramBut it is better to remove it. Knowing the cause is easy to solve. Generally, the control created after the single-choice button is a group box
(The above is the XYZ one), then we only need
You can solve this problem by checking the group attribute of box. If the control after this group of radio buttons is of another type, you just need to check the group attribute.

PS: the order of the radio button values depends on the order of the tab order.