WAS cluster series (10): Build a cluster: Step 8: configure the cluster on the WAS console.

WAS cluster series (10): Build a cluster: Step 8: configure the cluster on the WAS console.

Enter the IP address of the DM Management Server to log on to the WAS console (http: // 10.53.105.63: 9060/ibm/console/), as shown below:

(1) view node synchronization status

(2) Start the HTTP service

Node 1 (DM server ):

Click the options in the legend to start the HTTP Management Service and the HTTP service on node 1, for example:

Node 2. Similarly, start the HTTP service.

(3) create a Web server

Modify the following configurations as needed, for example:

After the configuration is complete, as shown in:

The configuration of another node is completed as follows:

You can verify the following web server configurations. Click "Stop" and "start" to view the symptoms, as shown below:

(4) set console preferences

(5) create a websphere application server Cluster and stop the default websphere application server, as shown below:

Delete the stopped server as follows:

Create a cluster as follows:

After configuring node synchronization, enter the following interface:

After the cluster is configured, you can view the topology, as shown in:

**************************************** ******************************** **************** 

Original works, from "Deep Blue blog" blog, welcome to reprint, reprint please be sure to indicate the source (http://blog.csdn.net/huangyanlong ).

Please leave a message or email (hyldba@163.com) indicating that there is an error. Thank you very much.

**************************************** ******************************** ****************

How to configure and release a cluster for a WebSphere cluster with two single nodes, one IHS node and one DM management Node

1. Add the two single nodes to dmgr using the command addNode. sh + host name + soap port to make them managed nodes.
2. Create a cluster.
3. Configure the data source to apply the scope to the cluster.
4. Publish an application and select a cluster to publish the application.
5. Modify the plug-in.

This is probably the case. If you have any difficulties, please mention it at 1.1. If you haven't done was, we suggest you find some information on the Internet.

How to configure IHS parameters in a WAS Cluster

Search for the Forum. My Post says, "Do you need to search for all parameters in the forum?