Router tplink845 The workaround for logging on to another interface:
Broadband connection errors may enter the cat's interface, be sure to connect the broadband line (or through the cat's network cable) to the router Wan, as follows:
Computer to connect the LAN port of the router, if it is a wireless terminal, make sure to connect to the correct wireless signal.
The router default SSID is: Tp-link_xxxx (x indicates four digits after the MAC address), which can be viewed at the bottom of the router's label:
At present, most routers will check the IP address of the WAN port, if the address and LAN port conflict, the management address automatically changed to 192.168.0.1.
Please check the administrative address, if the administrative address is tplogin.cn, it is recommended to use tplogin.cn login.
The back of the router is labeled as follows:
If there are other routers or devices connected to this router, if you connect through a wired cascade or wireless bridge, and the device has the same logon address as this router, you may be able to log on to the other device's management interface and recommend that you disconnect any other devices that are connected to the router. The router only connects to a computer or wireless terminal and then attempts to log on.
In addition to the network cable between the computer and the router, unplug the other network cable from the router, clear the browser history, and try the login interface.
Ways to clear the browser history (in IE browser for example): Open IE Browser, click the tool
>> Internet Options >> General, click Delete to clear the browser history and click OK.
If you follow the above method, the problem still cannot be solved, we recommend reset the router.
Reset method: In the case of power, press the reset button for 5-8 seconds to release, and then again refer to the correct line connection mode wiring and then try to log in.