1, the first computer shutdown, put the computer on the opposite side of the table, just like the picture, and then take out the screwdriver to the picture on the circle of the screws removed, the removal of attention to the position of the screws, the best different position screws in different places, because the size of the screw is not the same, Mixing will cause the laptop screws to tighten when it comes back, or it won't be screwed!!!
2, the screws are all removed after the notebook in turn, turn the front cover of the notebook, then use a screwdriver, or your fingernails, inserted into the notebook around the edge of the gap in slowly pry open on the OK, pry must be light, slowly, may be a little tight, do not worry about no problem, The most important thing is that when you feel like you've completely pried open, don't get excited. Even the touchpad is all pulled up because there's something connected to the keyboard, pull hard and you cry, like the picture shows, up a little bit, and then put the crimping pliers (I do not know what the name of that thing to call it, is the picture of the circle out of the place to dial up, the line from where to pull out the good, and then the keyboard directly out.
3, the keyboard to take away is this appearance, and then circled the place is hard drive, or the data cable to unplug (according to the second step of the drawing method), remove the screws that I circled, at this time you shake hard drive found hard drive, and then follow the direction of my cut head drag, the hard drive on the drag, Then shake the back side of the hard drive, remember to move a little bit, you can take out
4, remove the hard drive is this appearance, and then tear down the four-week screws, the change to the solid state hard drive, screw on OK, and then follow the steps to go backwards, it's good!!
Note:
1, must not put the screw position, do not mix
2, unplug the position of the line, where to pull from where to put back