Wi-Fi WDS relay instance

Basic supplement:

WDS is short for wireless distribution system. It is a wireless distributed system. Its function is to help communication between wireless base stations and wireless base stations in the wireless application field. WDS is a wireless distribution system, short for the extended wireless network deployment system. It forms a whole wireless network by connecting multiple wireless networks. Simply put, WDS uses two (or more) wireless broadband routers/aps to connect each other to extend the wireless signal to a more far-reaching range.

However, if the WDS function is used in the home, WDS serves as a repeater for the wireless network. We can enable this function on the wireless router to extend the wireless signal, this will cover more areas. A repeater is a process of bridging between Wireless AP and wireless router. The relay process does not affect the coverage and functions of wireless devices. Two wireless devices will be used to establish a WDS trust and communication relationship, greatly expanding the signal range of the wireless network.

Condition:

Know the SSID and password of the primary route

Relay:

There are several schemes for relay: (1) the AP master route LAN Wired Access Slave Route, start the Slave Route AP module, and the master route DHCP allocates an IP address in the same segment to the slave route, disable DHCP and assign IP addresses from the route to ensure the uniqueness of DHCP. Only responsible for transmitting wireless signals, that is, AP (Access Point)

650) This. width = 650; "src =" http://s3.51cto.com/wyfs02/M00/4B/F6/wKioL1Q2CSPCRBPZAACNrF_xdDs487.jpg "Title =" qq 41009115914.jpg "alt =" wkiol1q2cspcrbpzaacnrf_xdds487.jpg "/>

(2) Repeater (repeater mode) receives the SSID of the master route from the route, and enters the password for authentication. Set the lan ip address to the IP address of a network segment of the same master route, cannot conflict with the master route. The original master route signal is enhanced.

650) This. width = 650; "src =" http://s3.51cto.com/wyfs02/M00/4B/F6/wKioL1Q2DxyzBpqiAACT9gSUCpI027.jpg "Title =" qq 41009122755.jpg "alt =" wkiol1q2dxyzbpqiaact9gsucpi027.jpg "/>

(3) The master-slave routing in Bridge Mode must know two MAC addresses. Then, enable the bridge module and bind the MAC address of the other side to communicate with each other.

650) This. width = 650; "src =" http://s3.51cto.com/wyfs02/M02/4B/F5/wKiom1Q2Gk-xmgRLAACajENCy6k569.jpg "Title =" qq 41009131529.jpg "alt =" wKiom1Q2Gk-xmgRLAACajENCy6k569.jpg "/>

(4) In the WDS mode, because the preceding three routing modes are not available, and now all the routes have the WDS module, I will try to set WDS to expand the signal of the main route, if you do not need to set the master route, check the WDS option of the Slave Route, set the SSID signal to be sent by the Slave Route, set Internet access to dynamic IP, and set the lan ip address to a segment different from that of the master route, disable Slave Route DHCP. After the settings are completed, restart the service and you can use the SSID of the Slave Route. The DHCP address of the master route is assigned to the client to access the Internet.

This article from the "come, then the security of" blog, please be sure to keep this source http://8983615.blog.51cto.com/8973615/1561664

Wi-Fi WDS relay instance