1.win7 system WiFi Hotspot settings The most important first step is to know whether your network card supports hosting networks, if you do not support the tragedy of a vote veto, support to start the subsequent steps of the setting. See the following methods:
In cmd enter: netsh wlan show drivers command, after running as shown in figure (if support is displayed as: Yes, if you do not support me, you also do not want to set Win7 WiFi hotspot.) )
2. If the NIC supports hosting the network, you can go to the following WiFi settings:
A, run the command prompt as an administrator:
Start → attachment → command prompt (right-run as Administrator)
b, set the virtual WiFi network card:
To run a command at a command prompt: netsh wlan set hostednetwork mode=allow ssid=yourpc Key=yourwifi
This command has three parameters, mode: Whether the virtual WiFi card is enabled, and disallow is disabled.
SSID: Wireless network name, preferably in English (for example, YOURPC).
Key: Wireless network password, more than eight characters (take Yourwifi as an example).
The above three parameters can be used alone, such as using only Mode=disallow to disable the virtual WiFi card directly.
C, enable virtual WiFi network card
To run a command in an open window: netsh wlan start hostednetwork
After completing step b, be sure to enter this command again to enable
Once successful, the network connection will have one more card for "Microsoft Virtual WiFi Miniport Adapter" Wireless connection 2, for convenience, rename it to virtual WiFi. If not, just update the wireless network card driver is OK.
D, set up Internet Connection Sharing:
In the Network Connections window, right-click a network connection that is connected to the Internet, select Properties → share, and click Allow others. Connect (N) and select "Virtual WiFi".
Once identified, the "shared" word appears next to the shared network card icon, indicating that the broadband connection has been shared to virtual WiFi.
Tip: Some users may appear "An error occurred while Internet connection share access is enabled" Because Windows Firewall service is not turned on
Open method:
1. Use the key combination "Win+r", open the Run, and enter "Services.msc" (as shown in the picture)
2. Locate the Windows Firewall service in the service management interface and turn it on, and then set the share again.
Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer group: 189034526 welcome you to join