Win7 installation of Linux implementation of the dual system of the whole strategy

Recently, the original 32-bit system was re-installed to the 64-bit Win7 flagship version, but also want to try Linux, so in Win7 installed Linux implementation of the dual system, is Ubuntu 12.04 version, It is said that the latest version of the 14.0 has been released, but feel that the next 12.04 to try. ---Chen Xianxian tools/raw materials

• Notebook (Win7 Ultimate 64-bit system)
• 4G u disk (Linux does not have to be large, install window larger)
• Pre-prepared software: Soft disc pass, EASYBCD
• Linux system (ISO image file), this time I use the ubuntu12.04 version

Method/Step

2. A: To partition the disk, probably divided into about 30G of space (I split about 40G)

   For more details, see my other experience: http://jingyan.baidu.com/article/a17d52853ff59e8098c8f2ae.html

   1. Note: Used to install dual system is not required to build a blank volume!!! This will show up as freespace!!! when it's loaded.

   2. Cannot open the URL, you can search Baidu experience under the "Win7 flagship version of how to separate disk space and merge disk space

   ”

4. Second: The production of U disk system disk. Specific as follows:

   1. Insert the USB flash drive, open the soft disk pass, open-Select the next good system ISO file-boot-write hard disk image

   2. Then, as shown, "Hard drive" selects the drive where your USB stick is located (for example, my is J disk), "Write mode" select "Usb-hdd+"

   3. Then click "Format", by default (general default file system bit FAT32)

   4. Follow the quick start, select Syslinux

   5. Finally click "Write"

   In the end it will show you write successfully!

6. Three: Enter the BIOS interface

   1. Insert the USB stick, restart the notebook, press F2 at startup (some computers are f12,del and so on), enter the BIOS interface

   2. Select the USB HDD as the first option in the boot entry (you can actually choose a USB CD, I've tried it)

   3. Save the settings and leave.

8.  

   Four: (1) Enter the installation interface

   Follow these steps:

   1. Enter the "Installation Type" interface, if it shows: "The Computer currently has no deteted operating system "words, then look at the following 2-4 points, otherwise directly from the 5th look.

   2. " The computer currently has no deteted operating system "stating that your original Win7 systems were not detected, (the second figure below)"

   64-bit Win7 also presents another problem, is the GPT partition signature, if you do not do any processing, according to 1+2 two points you can log into the Ubuntu experience version, but the desktop installation, you will find that the partition is not recognized by your Win7 partition. So also need to open the desktop before the installation, open the terminal, enter a line of command: sudo dd if=/dev/zero of=/dev/sda bs=1 count=8 seek=512

   To eliminate the GPT partition table signature "--from the Linux commune network

   3. How do I enter the experience version and enter the terminal input command line? See 4th

   4. First, in the "Installation Type" screen click Exit (quit), it will automatically bring you into the experience version (rest assured), and then use the shortcut key Alt+f2, jump out of Run a command, and then you can see the Command Line window, please enter the sudo dd if=/ Dev/zero OF=/DEV/SDA Bs=1 count=8 seek=512  

   (in the following figure, you can see that I entered the wrong first time, and then again, show success!

   5. If you use the 4th step, after you turn off the command line window, click "Install Ubuntu" on the desktop. "And you will see it go back to the beginning of the interface, and it shows" you have installed the Win7 system "and the like (may be English ha). Otherwise continue (see figure Fourth below): .... (Add the 5th chart, select the language, choose Chinese, in the very bottom, to be relentless down to the point)

10. Four (2) Enter the installation interface: as shown, the original win7! has been detected

    1. Select the third option, "Custom".

    2. See no, the free space is 41940M, is probably the free space we have drawn out (more than I crossed out 40000M to be a bit larger, normal)

    3. Select free Space,

    Click "Free" section, select "Add" below, pop-up window below, fill in the partition empty

    Size, fill in the section below to mount, and then OK. "/" Partition, the "/home" partition is created in this way, and the swap partition is used to select "Swap Partition". (added: "/" is the primary partition, I filled out 30000M; "/home" is equivalent to "My Documents", size customization,/boot for driver, hundreds of MB), swap partition is not too large. ---reference "Baidu Library"

    4. Install the Boot launcher device, NOTE!!! Fill in the device where you mount the point "/boot" (the sixth figure can see the device of the above/boot and the device selection of the boot launcher below!) ）

    5. Click "Install Now"

12. Then go to the registered interface,

    1. Fill in Personal information ~ ~ ~

    2. Then start to install the software and system ... I have been waiting for several hours (maybe the internet is not good enough to scare you.) ）

    3. Installation successful, reboot! Unplug the USB drive!!! (Note: Otherwise the USB start-up item that was previously set causes the reboot to be re-installed again!) ）

    4. Enter the Win7 (definitely into the Win7, then you use the EASYBCD to make boot, let it appear system selection! ）

14. EasyBCD's on the pitch!

    1. Your original WIN7 system appears! (The familiar koala appeared ...) ）

    2. Open EASYBCD

    3. (1) Add new entry-(2) operating system Select "Linux/bsd"-(3) Drive Select: your previous/boot partition, the front of the Linux word, the size of the match you previously set (may be a bit more than you set a little bit!) )-(4) Add entry!

    4. Display Add success! You can see in "Viewing settings" that there is a Linux system under Win7! It worked.

16. Reboot the system and discover two options! Login-Enjoy the music ~ Welcome to like and collection, XIAN2R thank you!

    END

Precautions

• Computer to connect the power
• There's a network! WiFi is also available! Install software to download!
• System files can be downloaded from the Linux commune.
• When to insert a USB flash drive (when writing a USB drive with a floppy disk), when to unplug the USB flash drive (when the system is installed)
• When to press F2/f10/del (restart at the time before the official start to press the best)

Win7 installation of Linux implementation of the dual system of the whole strategy