Win7 laptop into wireless router to release WiFi signal

1. First of all. Press Menu key +r, open run, enter CMD. Or click Start, enter CMD in the search field

2.

And then enter

Netsh wlan set hostednetwork mode=allow SSID=LJF key=a123456789

①

Where mode is to enable the virtual wireless network card. Changing mode to disallow is the wireless virtual network card. ②ssid: The name of the wireless network, preferably in English, I here named for. LJF, (actually my initials)

Ii

Key: The wireless network password, is to 10 characters above, uses the letter to add the numeral the combination! This is a123456789. The only thing you need to change here is the SSID and the character behind the key. How you want to set up on how to set, as long as the system allows. Quite the meaning with the password account

3.

And then networking here click on Open Network and shared center, as shown in:

Right-click the icon, properties

This is the network I built, and it was an X before it was enabled.

I changed my name to WiFi for the convenience of the back. If you do not know that the wireless network is just established virtual wireless card, you can see the following typesetting, Microsoftvirtual WIFI ... This row, I know.

4. Then set in the broadband connection, right-click, properties-Share, and then "Allow other network users to connect through this computer Internet connection" tick,

Then select the following "Home network Connection", which is the virtual wireless network (WiFi) that you have just established. Then click OK, as shown

After it is established, as shown in the figure below, "shared" is shown later. "A few words.

5. Open the Virtual wireless network card.

After the broadband connection, and then run from the command prompt: Netsh wlan start hostednetwork, as shown in

　　If you need to close, just change the inside start stop to turn off the wireless network.

Now try to connect, the phone is connected to the router before the connection is made

This picture has been successfully connected to WiFi

　　Next share on the desktop set up a quick start mode, so that after easy to turn on or off

Create a new text document on your desktop, if you have already built:

Open the text to start WiFi and enter what you just want to enter:

After the input is complete, then change the suffix of the 2 document to bat: the following figure

OK, and then it will become the following icon

When you are done, you will not need to enter the cmd command at the beginning, just right click on the boot WiFi, "Run as admin"!!

Turn off WiFi, double-click the top icon to close it!

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join